Brass
Brass C360 Speeds and Feeds
Free machining and forgiving. Produces fine chips; keep flutes clear on deep cuts.
Milling Brass C360
Power is a rough estimate using the material unit power factor. Verify against your spindle rating.
Spindle speed
- RPM
Feed rate
- IPM
Material removal rate
- in3/min
Approx. spindle power
- HP
Editorial estimate only
These are conservative starting points, not a guarantee. Verify against manufacturer tooling data and your machine manual. Confirm spindle power, workholding and coolant before cutting.
Drilling Brass C360
Spindle speed
- RPM
Feed rate
- IPM
Editorial estimate only
These are conservative starting points, not a guarantee. Verify against manufacturer tooling data and your machine manual. Confirm spindle power, workholding and coolant before cutting.
Brass C360 reference values
Editorial estimates for illustration. Start on the low end and adjust to your tooling and machine.
| Operation | Surface speed | Chip load / feed | Unit power (approx) |
|---|---|---|---|
| Milling | 200-400 SFM (61-122 m/min) | 0.002-0.004 in/tooth (0.051-0.102 mm/tooth) | 0.5 HP per in3/min |
| Drilling | 200-300 SFM (61-91 m/min) | 0.004-0.008 in/rev (0.102-0.203 mm/rev) |
Frequently asked questions
What surface speed should I use for Brass C360?
A conservative milling range is 200-400 SFM (61-122 m/min). Coated carbide can run higher; HSS should stay on the low end.
What chip load should I use for Brass C360?
A typical milling chip load is 0.002-0.004 in/tooth (0.051-0.102 mm/tooth). Use the low end for small or fragile cutters and increase only as your setup allows.
Are these values safe to cut with?
These are starting points, not a guarantee. Always verify against your tooling manufacturer data and machine manual, and confirm spindle power, workholding and coolant before cutting.